|
Product Details:
Payment & Shipping Terms:
|
| Color: | White | Voltage: | DC5V |
|---|---|---|---|
| Power: | 0.12W | Waterproof: | IP68 |
| Products Diameter: | 9mm | Cable Length: | 8cm |
| Usage: | Lighting Signs | Warranty: | 3 Years |
| Paypal: | T/T,Paypal,Western Union |
1. IP68 Waterproof for outdoor advertising signs
2. 9mm small size, perfect for channel letter backlight
3. Low voltage, safe & energy saving
4. High brightness, consistent lighting
5. Cuttable at designated points, flexible layout
6. Easy wiring, fast installation
7. Multi-color optional, CE RoHS approved
8. Factory wholesale for signage projects
| Product Name | 9mm led pixel modules |
| Product Size | 9m diameter |
| Hole size | 9mm diameter. |
| Voltage | DC 5V |
| Power | 0.12W |
| Working Currency | 20mA |
| Bean Angle | 180° |
| Material | PVC |
| IP Rate | IP68 |
| Working temperature | -45℃～+70℃ |
| Warranty | Three Years |
| Package | 50pcs/string, 1000pcs/pcakge, 6000pcs/cuton |
| Emitting Color | Red, Yellow,Blue,Green,White,Voilet, RGB,Fullcolor. |
| Application | advertising letters,Name board, Wire bar,wall,building and stage decoration. |
1. Check all LED pixels for damage before installation. Do not use any lamps with broken shells or exposed wires.
2. This LED pixel works at low voltage. Do not connect to high-voltage mains directly, otherwise the lights will burn out immediately.
3. Cut the string only at the marked cutting points. Cutting at other positions will damage the circuit and make the pixels non-functional.
4. Keep the wiring joints sealed well after connection. Even though the lamp body is IP68 waterproof, the splice joints are not waterproof
without sealing.
5. Avoid pulling or stretching the wires violently during installation, which may cause internal wire breakage and light failure.
6. Do not bend the lamp bead body sharply. Sharp bending will damage the internal LED chip.
Driver select and installation:
1.Total load power of the driver should not be over than 80% of the driver rated power.
For example: Driver output:DC5V,40A, Rated power is 200W. the load power should not be over
Than 200*80%=160W. If every pcs light is 0.1W, Then the quantity should not be over than
160/0.1=1600pcs.
2.If there is more than one driver, Pls make sure that there is no reture circuit.Otherwise the drivers
Will be burn out.
3.Connect ways: When connect the string with driver, pls keep the beging and the end contacted with the main wire . and main wire must be 2.5 mm2 .
Pls check the picture as below:
Package:
Application pictures:
Common faults and troubleshooting:
1.the whole sting can’t be light up.
Resolve way:Inspect whether the string and driver main wire polar connected right or not.
2.One pcs light can’t be light up or not bright enough.
Resolve way:The light is break ,and exchange it with the good ones
3.The brightness and color of of the whole sting is not the same ,It caused by the led voltage is not enough.
Resolve way:Exchange the main wire to 2.5mm2 wire.
If you have more questions, Pls contact with me:
Contact : Alice Wang
Email:ledsignage_alice@163.com
Skype:alicewang2027
Whatapp:008613534016771
Website:http://www.mjlightingled.com
